TPDIN®

Communicating with TPDIN-Monitor-WEB via TELNET


______________________________________________________________________________________________________________________________________________________________ NOTE: This only works with the original TPDIN-MONITOR-WEB. It is not implemented in...

Email setup information for TPDIN®


Following are the existing TPDIN products and what type of SMTP they support: TPDIN-Monitor-WEB Non SSL – Port 25 TPDIN-Monitor-WEB2 Non SSL – Port 25 ; SSL – Port 465 TPDIN-Monitor-WEB3 Non SSL – Port 25 ; TLS...

Can I publish my ProWeatherStation data online?


______________________________________________________________________________________________________________________________________________________________ The TP2700WC ProWeatherStation data can be published online using the WeatherSmart...

My WEB3 is connected to the MPPT solar controller with an RS485 serial cable but the current readings are all zero on the MPPT display and in the WEB3 MPPT page.


______________________________________________________________________________________________________________________________________________________________ The ground between the V- load output on the MPPT solar controller and the...

Where can I get replacement 4 pin connectors for TPDIN® series product?


______________________________________________________________________________________________________________________________________________________________ You can buy replacement connectors at Digikey.com Specific links are below: 4 PIN...

Why am I seeing erroneous shunt current readings on my TPDIN-Monitor-WEB2 and TPDIN-Monitor-WEB3?


Electrical noise from MPPT Solar controllers or noisy power sources can cause erroneous shunt current readings on the WEB2 and WEB3. The reading will seem to fluctuate widely. To improve this issue, be sure that the WEB2/3 is connected to the...

Unlicensed Timeout


______________________________________________________________________________________________________________________________________________________________ Please go to http://(IPADDRESS)/license.htm Provide us with the Hardware ID. We will...

How can I change my TPDIN-Monitor-WEB2 relays to Normally Closed (NC)


______________________________________________________________________________________________________________________________________________________________ Unofficial hack. Note: This is an unofficial hack. Do this at your own risk. You can...

What does the log entry "System Init *V2.3.5 WDT was triggered" mean?


______________________________________________________________________________________________________________________________________________________________ The TPDIN2 rebooted via a power cycle or a software reboot. Note: V2.3.5 is the...

What do the error codes in the log file mean?


______________________________________________________________________________________________________________________________________________________________ If it is a mail send error code, you can see a list here: Common problems that cause...

How can I enable or disable relay functions in the TPDIN-Monitor-WEB2 via Linux scripting?


______________________________________________________________________________________________________________________________________________________________ You can use HTTP GET requests to enable or disable the relay controls. Assume the IP...

Accessing Data and Controlling Relays on TPDIN-Monitor-WEB2 via HTTP


______________________________________________________________________________________________________________________________________________________________ You can access the real time readings and control relays on the TPDIN-Monitor-WEB2 via...

Saving Power via Time of Day and Periodic Power Cycle Control – TPDIN-Monitor-WEB


______________________________________________________________________________________________________________________________________________________________ Problem: Sometimes your RemotePro® system doesn’t have enough power to keep your...

How can I reset my TPDIN® product to factory defaults?


______________________________________________________________________________________________________________________________________________________________ TPDIN-Monitor-WEB: Hold down the reset button while powering up the TPDIN-Monitor-WEB...

I cannot send email from my TPDIN® series product?


______________________________________________________________________________________________________________________________________________________________ Following are the existing TPDIN products and what type of SMTP they...

What network port do the TPDIN® products communicate on?


______________________________________________________________________________________________________________________________________________________________ 80 or 8000. This port can be changed in the user interface.

How many characters for username and password in the TPDIN® products?


______________________________________________________________________________________________________________________________________________________________ TPDIN-Monitor-WEB: username and password fields on the Network Page accept up to 10...

Template File for the TPDIN® using Zabbix


______________________________________________________________________________________________________________________________________________________________ If you use Zabbix for network monitoring, we have a starter template file available to...

Why can't I open the TPDIN® web pages with my browser even though my computer is on the same subnet?


______________________________________________________________________________________________________________________________________________________________ If you are using an antivirus program like AVAST, the WEBSHIELD could be blocking the...

My real time clock isn't updating on my TPDIN®


______________________________________________________________________________________________________________________________________________________________ Make sure the unit is connected to the internet. If set for static IP check to make...

I was updating the firmware on the TPDIN-Monitor-WEB2 and now I can't access the unit?


______________________________________________________________________________________________________________________________________________________________ A communications problem during upgrade may have caused corruption in the flash memory...