I was updating the firmware on the TPDIN-Monitor-WEB2 and now I can’t access the unit?

7TPDIN® Viewed: 38

______________________________________________________________________________________________________________________________________________________________

A communications problem during upgrade may have caused corruption in the flash memory or the “Upgrade and Reboot” button was double clicked or pressed twice.

Follow these steps to recover:

  1. Press and hold the reset button while powering up the unit.
  2. Release button as soon as you see a green Link LED on the RJ45 connector.
  3. Access the unit via the Discovery Tool or on its previous IP address and immediately go to Upgrade and re-load the firmware. Be careful not to double click the “Upgrade and Reboot” button.